xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1282
Community Ports : 9-10 Community VLAN: 40
Private VLAN 200
------------------
Promiscuous Ports: 11
Trunk Ports : 12
Isolated Ports : 13-15 Isolated VLAN : 50
Community Ports : 16-18 Community VLAN: 60
121-18 enable pvid auto_assign
Description
This command is used to enable the auto-assignment of PVID. If auto-assign PVID is disabled,
PVID can only be changed by PVID configuration (user changes explicitly). The VLAN
configuration will not automatically change PVID. If Auto-assign PVID is enabled, PVID can be
changed by PVID or VLAN configuration. When a user configures a port to VLAN X’s untagged
membership, this port’s PVID will be updated with VLAN X. PVID is updated with the last item of
the VLAN list. When a user removes a port from the untagged membership of the PVID’s VLAN,
the port’s PVID will be assigned with “default VLAN”.
Format
enable pvid auto_assign
Parameters
None. The default setting is enabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the auto-assign PVID:
DGS-3620-28PC:admin#enable pvid auto_assign
Command: enable pvid auto_assign
Success.
To Next Page
Loading...
Need help?
General