D-Link xStack DGS-3620 Series - Page 1356

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1351
CFM Extension
Event description: AIS condition detected
Log Message: AIS condition detected. MD Level:<mdlevel>,
VLAN:<vlanid>, Local(Port <[unitID:]portNum>,
Direction:<mepdirection>, MEPID:<mepid>)
Parameters description:
vlanid: Represents the VLAN identifier of the MEP.
mdlevel: Represents the MD level of the MEP.
unitID: Represents the ID of the device in the stacking system.
portNum: Represents the logical port number of the MEP.
mepdirection: Represents the direction of the MEP. This can be
"inward" or "outward".
mepid: Represents the MEPID of the MEP.
Notice
Event description: AIS condition cleared
Log Message: AIS condition cleared. MD Level:<mdlevel>,
VLAN:<vlanid>, Local(Port <[unitID:]portNum>,
Direction:<mepdirection>, MEPID:<mepid>)
Parameters description:
vlanid: Represents the VLAN identifier of the MEP.
mdlevel: Represents the MD level of the MEP.
unitID: Represents the ID of the device in the stacking system.
portNum: Represents the logical port number of the MEP.
mepdirection: Represents the direction of the MEP. This can be
"inward" or "outward".
mepid: Represents the MEPID of the MEP.
Notice
Event description: LCK condition detected
Log Message: LCK condition detected. MD Level:<mdlevel>,
VLAN:<vlanid>, Local(Port <[unitID:]portNum>,
Direction:<mepdirection>, MEPID:<mepid>)
Parameters description:
vlanid: Represents the VLAN identifier of the MEP.
mdlevel: Represents the MD level of the MEP.
unitID: Represents the ID of the device in the stacking system.
portNum: Represents the logical port number of the MEP.
mepdirection: Represents the direction of the MEP. This can be
"inward" or "outward".
mepid: Represents the MEPID of the MEP.
Notice
Event description: LCK condition cleared
Log Message: LCK condition cleared. MD Level:<mdlevel>,
VLAN:<vlanid>, Local(Port <[unitID:]portNum>,
Direction:<mepdirection>, MEPID:<mepid>)
Parameters description:
vlanid: Represents the VLAN identifier of the MEP.
mdlevel: Represents the MD level of the MEP.
unitID: Represents the ID of the device in the stacking system.
portNum: Represents the logical port number of the MEP.
mepdirection: Represents the direction of the MEP. This can be
"inward" or "outward".
mepid: Represents the MEPID of the MEP.
Notice
Port
Event description: port linkup
Log Message: Port <port> link up, <nway>
Parameters description:
port: Represents the logical port number.
nway: Represents the speed and duplex of link.
Informational
Event description: port linkdown
Log Message: Port <port> link down
Parameters description:
port: Represents the logical port number.
Informational
DDM Event description: DDM exceeded or recover from DDM alarm
threshold
Log Message: DDM Port <[unitID:]portNum> optic module
[thresholdType] [exceedType] the [thresholdSubType] alarm
threshold
Parameters description:
unitID: The unit ID.
portNum: The port number.
thresholdType: the DDM threshold type. The value should be one
of the following values: temperature, supply voltage, bias current,
TX power, RX power.
exceedType: indicate exceed threshold or recover to normal event,
Critical