EasyManua.ls Logo

D-Link xStack DGS-3620 Series - Page 1362

D-Link xStack DGS-3620 Series
1371 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1357
type conflicts with this router's
authentication key or authentication type.
Implementation of this trap is optional.
Binding objects:
(1) vrrpTrapPacketSrc
(2) vrrpTrapAuthErrorType
Port Security
swL2PortSecurityViolationTrap
When the port security trap is enabled,
new MAC addresses that violate the pre-
defined port security configuration will
trigger trap messages to be sent out.
Binding objects:
(1)swPortSecPortIndex
(2)swL2PortSecurityViolationMac
1.3.6.1.4.1.171.11.118.
X.2.100.1.2.0.2,(X:mod
ule ID)
Safe Guard
swSafeGuardChgToNormal
This trap indicates system change
operation mode from axhausted to normal.
Binding objects:
(1) swSafeGuardCurrentStatus
1.3.6.1.4.1.171.12.19.4.
1.0.2
swSafeGuardChgToExhausted
This trap indicates System change
operation mode from normal to exhausted.
Binding objects:
(1) swSafeGuardCurrentStatus
1.3.6.1.4.1.171.12.19.4.
1.0.1
LBD
swPortLoopOccurred The trap is sent when a port loop occurs.
Binding objects:
(1) swLoopDetectPortIndex
1.3.6.1.4.1.171.12.41.1
0.0.1
swPortLoopRestart
The trap is sent when a port loop restarts
after the interval time.
Binding objects:
(1) swLoopDetectPortIndex
1.3.6.1.4.1.171.12.41.1
0.0.2
swVlanLoopOccurred
The trap is sent when a port loop occurs
under LBD VLAN-based mode.
Binding objects:
(1) swLoopDetectPortIndex
(2) swVlanLoopDetectVID
1.3.6.1.4.1.171.12.41.1
0.0.3
swVlanLoopRestart
The trap is sent when a port loop restarts
under LBD VLAN-based mode after the
interval time.
Binding objects:
(1) swLoopDetectPortIndex
(2) swVlanLoopDetectVID
1.3.6.1.4.1.171.12.41.1
0.0.4
BPDU Attack
Protection
swBpduProtectionUnderAttacking
Trap
BPDU attack happened, enter drop / block
/ shutdown mode.
1.3.6.1.4.1.171.12.76.4.
0.1
swBpduProtectionRecoveryTrap
BPDU attack automatically recover
1.3.6.1.4.1.171.12.76.4.
0.2
IMPB
swIpMacBindingViolationTrap
When the IP-MAC Binding trap is enabled,
if there's a new MAC that violates the pre-
defined port security configuration, a trap
will be sent out.
Binding objects:
(1) swIpMacBindingPortIndex
(2) swIpMacBindingViolationIP
(3) swIpMacBindingViolationMac
1.3.6.1.4.1.171.12.23.5.
0.1
swIpMacBindingIPv6ViolationTrap
When the IP-MAC Binding trap is enabled,
if there's a new MAC that violates the pre-
defined IPv6 IMPB configuration, a trap
will be sent out.
Binding objects:
(1) swIpMacBindingPortIndex
(2) swIpMacBindingViolationIPv6Addr
(3) swIpMacBindingViolationMac
1.3.6.1.4.1.171.12.23.5.
0.4
swIpMacBindingShutdownTrap
When the rate limiting is shutdown mode
and the DHCP rate excludes the limiting, a
trap will be sent out.
Binding objects:
swIpMacBindingPortIndex
1.3.6.1.4.1.171.12.23.5.
0.5
swIpMacBindingRecoveryTrap
When the port is shutdown by DHCP rate
limiting and the auto-recovery timer is
timeout, a trap will be sent out.
Binding objects:
1.3.6.1.4.1.171.12.23.5.
0.6

Table of Contents

Related product manuals