D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
152
Format
show ipfdb {[ip_address <ipaddr> | interface <ipif_name 12> | port <port>]}
Parameters
ip_address - (Optional) Specifies the IP address of the forwarding table.
<ipaddr> - Enter the IP address to be displayed.
interface - (Optional) Specifies the interface name of the forwarding table.
<ipif_name 12> - Enter the interface name here. This name can be up to 12 characters long.
port - (Optional) Specifies the port to be displayed.
<port> - Enter the port number to be displayed.
Restrictions
None.
Example
To display the IP address forwarding table on the Switch:
DGS-3620-28PC:admin# show ipfdb
Command: show ipfdb
Interface IP Address Port Learned
------------ ---------------- --------- ---------
Total Entries: 0
DGS-3620-28PC:admin#
7-9 config arp_aging time
Description
This command is used to set the maximum amount of time, in minutes, that an ARP entry can
remain in the switch’s ARP table, without being accessed, before it is dropped from the table.
Format
config arp_aging time <min 0-65535>
Parameters
<min 0-65535> - The ARP age-out time, in minutes. The default is 20 minutes. The range is 0 to
65535 minutes.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English