D-Link xStack DGS-3620 Series - Page 158

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
153
Example
To configure the ARP aging time:
DGS-3620-28PC:admin#config arp_aging time 30
Command: config arp_aging time 30
Success.
DGS-3620-28PC:admin#
7-10 config arp_retry times
Description
This command is used to configure the ARP retry times.
Format
config arp_retry times <value 0-4>
Parameters
<value 0-4> - Enter the ARP retry times value here. This value must be between 0 and 4.
Entering 0 will only send one ARP request without any retries. By default, this value is 4.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
This example shows how to configure the ARP retry times value.
DGS-3620-28PC:admin#config arp_retry times 2
Command: config arp_retry times 2
Success.
DGS-3620-28PC:admin#