D-Link xStack DGS-3620 Series - Page 180

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
175
12-12 config bgp network
Description
This command is used to configure the attribute associated with the network advertised by the
Border Gateway Protocol (BGP).
Format
config bgp network [<network_address> | ipv6 <ipv6_networkaddr>] [route_map
<map_name 16> | clear_routemap]
Parameters
<network_address> - Represents the local IPv4 network that BGP will advertise.
ipv6 – Specifies the local IPv6 network that BGP will advertise.
<ipv6_networkaddr> - Enter the IPv6 network address here.
route_map - Specifies the route map applied to the advertised networks.
<map_name 16> - Enter the route map name here. This name can be up to 16 characters
long.
clear_routemap - Removes the route map applied to the network.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
Change the network 10.108.0.0/16 to clear a route map:
DGS-3620-28PC:admin# config bgp network 10.108.0.0/16 clear_routemap
Command: config bgp network 10.108.0.0/16 clear_routemap
Success.
DGS-3620-28PC:admin#
12-13 delete bgp network
Description
This command is used to delete the networks advertised by the Border Gateway Protocol (BGP).
Format
delete bgp network [[<network_address> | all] | ipv6 [<ipv6_networkaddr> | all]]
Parameters
<network_address> - Specifies the IPv4 network address of the entry that will be deleted.
all – Specifies to delete all IPv4 BGP networks.
ipv6 – Specifies the IPv6 network address of the entry that will be deleted.