xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
176
<ipv6_networkaddr> - Enter the IPv6 network address here.
all – Specifies to delete all IPv6 BGP networks.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To delete network 10.108.0.0/16 to be advertised in the BGP updates:
DGS-3620-28PC:admin# delete bgp network 10.108.0.0/16
Command: delete bgp network 10.108.0.0/16
Success.
12-14 show bgp network
Description
This command is used to show the networks advertised by the Border Gateway Protocol (BGP).
Format
show bgp network {[<network_address> | ipv6 {<ipv6_networkaddr>}]}
Parameters
<network_address> - (Optional) Enter the local IPv4 network address that BGP will advertise.
ipv6 - (Optional) Specifies the local IPv6 network address that BGP will advertise.
<ipv6_networkaddr> - Enter the local IPv6 network address that BGP will advertise.
If the specific network address is not specified, all network addresses of IPv4 or IPv6 will be
displayed.
Restrictions
None. (EI Mode Only Command)
Example
To show network 10.108.0.0/16 advertised in the BGP updates:
To Next Page
Loading...
