D-Link xStack DGS-3620 Series - Page 225

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
220
Example
This example displays the BGP trap state:
DGS-3620-28PC:admin# show bgp trap_state
Command: show bgp trap_state
BGP Trap State :
BGP Peer Established : Enabled
BGP Peer Idle : Enabled
DGS-3620-28PC:admin#
12-53 config bgp scan_timer
Description
This command is used to configure the BGP scan timer value. BGP will check the next hop
whether it is reachable from the BGP route before the timer expires.
Format
config bgp scan_timer [<sec 5-60> | default]
Parameters
<sec 5-60> - Set the BGP scan timer value from 5 to 60 seconds. Default is 60 seconds
default - Set the BGP scan timer to the default value.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
This example configures the BGP scan timer to 30 seconds:
DGS-3620-28PC:admin# config bgp scan_timer 30
Command: config bgp scan_timer 30
Success.
DGS-3620-28PC:admin#
12-54 config bgp aggregate_next_hop_check
Description
This command is used to configure the BGP aggregated routes’ next hop check. Only the routes
with the same next hop attribute can be aggregated if the BGP aggregate next hop check is
enabled.