D-Link xStack DGS-3620 Series - Page 224

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
219
12-51 config bgp trap
Description
This command is used to configure the BGP trap state.
Format
config bgp trap [peer_established | peer_idle | all] [enable | disable]
Parameters
peer_established - Enable or disable the sending of the peer established trap. This default value
is disabled.
peer_idle - Enable or disable the sending of the peer idle trap. This default value is disabled.
all - Enable or disable the sending of both the peer idle and established trap. This default value is
disabled.
enable - Specifies that the trap feature will be enabled.
disable - Specifies that the trap feature will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
This example disables the BGP peer idle trap state:
DGS-3620-28PC:admin# config bgp trap peer_idle disable
Command: config bgp trap peer_idle disable
Success.
DGS-3620-28PC:admin#
12-52 show bgp trap_state
Description
This command is used to show the BGP trap state.
Format
show bgp trap_state
Parameters
None.
Restrictions
None. (EI Mode Only Command)