D-Link xStack DGS-3620 Series - Page 30

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
25
2-21 reboot
Description
This command is used to restart the switch.
Format
reboot {force_agree}
Parameters
force_agree – (Optional) Specifies to immediately execute the reboot command without further
confirmation.
Restrictions
Only Administrator-level users can issue this command.
Example
To restart the switch:
DGS-3620-28PC:admin#reboot
Command: reboot
Are you sure you want to proceed with the system reboot?(y/n)
Please wait, the switch is rebooting…
2-22 reset
Description
This command is used to reset all switch parameters to the factory defaults.
Format
reset {[config | system]} {force_agree}
Parameters
config - (Optional) Specifies this keyword and all parameters are reset to default settings.
However, the device will neither save nor reboot.
system - (Optional) Specifies this keyword and all parameters are reset to default settings. Then
the switch will do factory reset, save, and reboot.
force_agree - (Optional) Specifies and the reset command will be executed immediately without
further confirmation.
Note: If no keyword is specified, all parameters will be reset to default settings except IP
address, user account, and history log, but the device will neither save nor reboot.