D-Link xStack DGS-3620 Series - Page 339

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
334
20-41 debug bgp error state
Description
This command is use for setting the flag of debugging information about BGP Error not need send
BGP NOTIFICATION.
Format
debug bgp error state [enable | disable]
Parameters
enable - Enable the BGP debug function.
disable - Disable the BGP debug function.
Restrictions
Only Administrator-level users can issue this command. (EI Mode Only Command)
Example
Configure BGP to enable error debug flag:
DGS-3620-28PC:admin# debug bgp error state enable
Command: debug bgp error state enable
Success.
DGS-3620-28PC:admin#
Output Examples: After configure BGP to enable error debug flag, it may print following information
when error happens.
BGP: 10.1.1.1-10.2.2.2, NHop Validate: Invalid NHop address 250.3.0.0/8
received.
BGP: Hold-Timer: Invalid Peer.
20-42 debug bgp show global_info
Description
This command is used for displaying global information of current BGP instance.
Format
debug bgp show global_info
Parameters
None.