D-Link xStack DGS-3620 Series - Page 344

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
339
DGS-3620-28PC:admin# debug bgp show network
Command: debug bgp show network
Network Route Map
------------- -----------
192.168.0.0/8 NULL
172.16.0.0/16 map1
Total Entries :2
DGS-3620-28PC:admin#
20-46 debug bgp show aggregate
Description
This command is used for displaying current aggregate’s configuration in BGP protocol stack.
Format
debug bgp show aggregate {ipv6 unicast}
Parameters
ipv6 unicast – (Optional) Specifies to debug the IPv6 unicast address family.
Restrictions
Only Administrator-level users can issue this command. (EI Mode Only Command)
Example
Configure BGP to show aggregate information:
DGS-3620-28PC:admin# debug bgp show aggregate
Command: debug bgp show aggregate
Network Summary Only AS Set Suppress Count
------------- ------------ ------ -------------
192.168.0.0/8 YES NO 0
172.16.0.0/16 NO NO 2
Total Entries :2
DGS-3620-28PC:admin#
20-47 debug bgp show damp
Description
This command is used for displaying current dampening configuration and corresponding dynamic
information in BGP protocol stack.