D-Link xStack DGS-3620 Series - Page 367

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
362
Format
debug super_vlan state [enable | disable]
Parameters
state - Specifies the super VLAN debug function state.
enable - Specifies that the super VLAN debug function will be enabled.
disable - Specifies that the super VLAN debug function will be disabled.
Restrictions
Only Administrator-level users can issue this command.
Example
To disable the super VLAN Debug Function:
DGS-3620-28PC:admin# debug super_vlan state disable
Command: debug super_vlan state disable
Success.
DGS-3620-28PC:admin#
After enabling super VLAN debug, the following information may appear when receive an ARP
packet form sub VLAN.
The ARP request packet received from sub vlan 200.
20-78 debug show address_binding binding_state_table
Description
This command is used to display the binding state of the entries in the binding state table.
Format
debug show address_binding binding_state_table [nd_snooping | dhcpv6_snooping]
Parameters
nd_snooping - Specifies to debug ND Snooping bound addresses in the binding state table.
dhcpv6_snooping - Specifies to debug DHCPv6 Snooping bound addresses in the binding state
table.
Restrictions
Only Administrator-level users can issue this command.