D-Link xStack DGS-3620 Series - Page 390

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
385
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable the DHCP relay function:
DGS-3620-28PC:admin#disable dhcp_relay
Command: disable dhcp_relay
Success.
DGS-3620-28PC:admin#
22-19 show dhcp_relay
Description
This command is used to display the current DHCP relay configuration.
Format
show dhcp_relay {ipif <ipif_name 12>}
Parameters
ipif – (Optional) Specifies the IP interface name.
<ipif_name 12> - Enter the IP interface name. The IP interface name can be up to 12
characters long.
Note: If no parameter is specified, the system will display all DHCP relay configurations.
Restrictions
None.
Example
To display the DHCP relay status:
DGS-3620-28PC:admin#show dhcp_relay
Command: show dhcp_relay
DHCP/BOOTP Relay Status : Disabled
DHCP/BOOTP Relay Unicast Status : Disabled
DHCP/BOOTP Hops Count Limit : 4
DHCP/BOOTP Relay Time Threshold : 0
DHCP Vendor Class Identifier Option 60 State: Disabled
DHCP Client Identifier Option 61 State: Disabled