D-Link xStack DGS-3620 Series - Page 43

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
38
3-8 config 802.1x capability ports
Description
This command is used to configure port capability.
Format
config 802.1x capability ports [<portlist> | all] [authenticator | none]
Parameters
<portlist> - Enter a range of ports to be configured.
all - Specifies to configure all ports.
authenticator - The port that wishes to enforce authentication before allowing access to services
that are accessible via that port adopts the authenticator role.
none – Disable authentication on specified port.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure port capability for ports 1 to 10:
DGS-3620-28PC:admin#config 802.1x capability ports 1-10 authenticator
Command: config 802.1x capability ports 1-10 authenticator
Success.
DGS-3620-28PC:admin#
3-9 config 802.1x fwd_pdu ports
Description
This command is used to configure the 802.1X PDU forwarding state on specific ports of the
switch.
Format
config 802.1x fwd_pdu ports [<portlist> | all] [enable | disable]
Parameters
<portlist> - Enter a range of ports to be configured.
all - Specifies all ports.
enable - Enable the 802.1X PDU forwarding state.
disable - Disable the 802.1X PDU forwarding state.