D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
458
28-6 show dvmrp nexthop
Description
This command is used to display the DVMRP routing next hop table.
Format
show dvmrp nexthop {ipaddress <network_address> | ipif <ipif_name 12>}
Parameters
ipaddress - (Optional) Specifies the IP address and netmask of the destination used.
<network_address> - Enter the IP address and netmask of the destination used here.
ipif - (Optional) Specifies the IP interface name used for the display.
<ipif_name 12> - Enter the IP interface name used for the display here. This name can be up
to 12 characters long.
If no parameter is specified, the system will display all the DVMRP routing next hop tables.
Restrictions
None. (EI Mode Only Command)
Example
To display DVMRP routing next hop table:
DGS-3620-28PC:admin# show dvmrp nexthop
Command: show dvmrp nexthop
DVMRP Routing Next Hop Table
Source Address/NetMask Interface Name Type
---------------------- --------------- ------
10.0.0.0/8 ip2 Leaf
10.0.0.0/8 ip3 Leaf
20.0.0.0/8 System Leaf
20.0.0.0/8 ip3 Leaf
30.0.0.0/8 System Leaf
30.0.0.0/8 ip2 Leaf
Total Entries : 6
DGS-3620-28PC:admin#
28-7 show dvmrp routing_table
Description
This command is used to display the DVMRP routing table.
Format
show dvmrp routing_table {ipaddress <network_address>}

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English