D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
513
Format
show filter extensive_netbios
Parameters
None.
Restrictions
None.
Example
To display the extensive NetBIOS filter state on the switch:
DGS-3620-28PC:admin#show filter extensive_netbios
Command: show filter extensive_netbios
Enabled Ports: 1:1-1:3
DGS-3620-28PC:admin#
39-3 config filter netbios
Description
This command is used to configure the Switch to deny NetBIOS packets on the network. Enabling
of the filter NetBIOS state will create one access profile and three access rules per port
automatically (UDP ports 137 and138 and TCP port 139). Filter commands in this file will share the
same access profile.
Format
config filter netbios [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter the port or range of ports to configure.
all - Specifies to configure all ports.
state - Specifies the status of the filter to block NetBIOS packets.
enable - Enable the filter to block NetBIOS packets.
disable - Disable the filter to block NetBIOS packets.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the NetBIOS filter state:
DGS-3620-28PC:admin#config filter netbios 1-10 state enable

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English