D-Link xStack DGS-3620 Series - Page 541

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
536
43-6 create igmp static_group
Description
This command is used to create an IGMP static group on the Switch.
Format
create igmp static_group ipif <ipif_name 12> group <ipaddr>
Parameters
ipif – Specifies the IP interface name used for this configuration.
<ipif_name 12> - Enter the IP interface name used for this configuration here. This name can
be up to 12 characters long.
group - Specifies the multicast IP address used.
<ipaddr> - Enter the multicast IP address used here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create an IGMP static group, with the multicast IP address 225.0.0.2 on the IP interface
“System”:
DGS-3620-28PC:admin# create igmp static_group ipif System group 225.0.0.2
Command: create igmp static_group ipif System group 225.0.0.2
Success.
DGS-3620-28PC:admin#
43-7 delete igmp static_group
Description
This command is used to delete IGMP static group(s) on the switch.
Format
delete igmp static_group ipif <ipif_name 12> [group <ipaddr> | all]
Parameters
ipif – Specifies the IP interface name used for this configuration.
<ipif_name 12> - Enter the IP interface name used for this configuration here. This name can
be up to 12 characters long.
group - Specifies the multicast IP address used.
<ipaddr> - Enter the multicast IP address used here.
all – Specifies that all the multicast IP addresses will be deleted.