D-Link xStack DGS-3620 Series - Page 552

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
547
Command: config igmp_snooping querier vlan_name default query_interval 125
state enable
Success.
DGS-3620-28PC:admin#
45-3 config router_ports
Description
This command is used to designate a range of ports as being connected to multicast-enabled
routers. This will ensure that all packets with such a router as its destination will reach the
multicast-enabled router, regardless of protocol.
Format
config router_ports [<vlan_name 32> | vlanid <vlanid_list>] [add | delete] <portlist>
Parameters
<vlan_name 32> - Enter the name of the VLAN on which the router port resides.
vlanid - Specifies the VLAN ID list.
<vlanid_list> - Enter the VLAN ID list.
add - Specifies to add the router ports.
delete - Specifies to delete the router ports.
<portlist> - Enter a range of ports to be configured.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To set up static router ports:
DGS-3620-28PC:admin#config router_ports default add 1-10
Command: config router_ports default add 1-10
Success.
DGS-3620-28PC:admin#
45-4 config router_ports_forbidden
Description
This command is used to designate a range of ports as being not connected to multicast-enabled
routers. This ensures that the forbidden router port will not propagate routing packets out.