xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
595
Format
show ip standard access_list {<list_name 16>}
Parameters
<list_name 16> - (Optional) Enter the name of the access list used here. This name can be up to
16 characters long.
If no parameter is specified, all access lists on the Switch will be displayed.
Restrictions
None.
Example
To display the information of an access list named “List1”:
DGS-3620-28PC:admin#show ip standard access_list List1
Command: show ip standard access_list List1
IP standard Access_list: List1
Total entries number : 1
filter : permit 10.1.1.1/8
49-9 clear ip prefix_list counter
Description
This command is used to clear prefix list hit counters. The hit count is a value indicating the
number of matches to a specific prefix list entry.
Format
clear ip prefix_list counter [<list_name 16> {<network_address>} | all]
Parameters
<list_name 16> - Enter the name of the prefix list from which the hit count is to be cleared. This
name can be up to 16 characters long.
<network_address> - (Optional) Enter the IPv4 network address used here that will be used to
clear the hit count.
all - Specifies that all the prefix list counters will be cleared.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
To Next Page
Loading...
Need help?
General