D-Link xStack DGS-3620 Series - Page 604

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
599
and 20000.
<min 1-255> - Enter the dampening time used here. This value must be between 1 and 255
minutes.
<min 1-45> - Enter the dampening time used here. This value must be between 1 and 45
minutes.
ipv6 next_hop - Specifies the IPv6 next hop attribute.
<ipv6addr> - Specifies the IPv6 address to set.
metric_type - Specifies to set the metric type of the imported route.
type_1 - Specifies an OSPF AS-external type-1.
type_2 - Specifies an OSPF AS-external type-2.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure a route map named “map1” and add one sequence ID of 20 to the route map:
DGS-3620-28PC:admin# config route_map map1 add sequence 20
Command: config route_map map1 add sequence 20
Success.
DGS-3620-28PC:admin#
To configure the route map to set the metric and to set the dampening parameters:
DGS-3620-28PC:admin# config route_map map1 sequence 10 set add metric 50
Command: config route_map map1 sequence 10 set add metric 50
Success.
DGS-3620-28PC:admin# config route_map map1 sequence 10 set add dampening 15 750
2000 60 15
Command: config route_map map1 sequence 10 set add dampening 15 750 2000 60 15
Success.
DGS-3620-28PC:admin#
49-12 delete route_map
Description
This command is used to delete a route map configuration.
Format
delete route_map [map_name <map_name 16> {all_seqence} | all]
Parameters
map_name - Specifies the route map name used.