xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
635
Format
config ipv6 nd ns ipif <ipif_name 12> retrans_time <millisecond 0-4294967295>
Parameters
<ipif_name 12> - Enter the name of the interface. The maximum length is 12 characters.
retrans_time - Specifies the neighbor solicitation’s retransmit timer in milliseconds. It has the
same value as ra retrans_time in the config ipv6 nd ra command. If one is configured, the
other will change too.
<millisecond 0-4294967295> - Enter the neighbor solicitation’s retransmit timer in
milliseconds. It has the same value as ra retrans_time in the config ipv6 nd ra command. If
one is configured, the other will change too. The value is between 0 and 4294967295
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the NS retransmit time of a specified interface:
DGS-3620-28PC:admin#config ipv6 nd ns ipif System retrans_time 400
Command: config ipv6 nd ns ipif System retrans_time 400
Success.
52-7 config ipv6 nd ra ipif
Description
This command is used to configure the RA parameters of a specified interface.
Format
config ipv6 nd ra ipif <ipif_name 12> {state [enable | disable] | life_time <sec 0-9000> |
reachable_time <millisecond 0-3600000> | retrans_time <millisecond 0-4294967295> |
hop_limit <value 0-255> | managed_flag [enable | disable] | other_config_flag [enable |
disable] | min_rtr_adv_interval <sec 3-1350> | max_rtr_adv_interval <sec 4-1800>}(1)
Parameters
<ipif_name 12> - Enter the name of the interface.
state - Specifies the router advertisement status.
enable - Enable the router advertisement state.
disable - Disable the router advertisement state.
life_time - Specifies the lifetime of the router as the default router, in seconds.
<sec 0-9000> - Enter the time between 0 and 9000 seconds.
reachable_time - Specifies the amount of time that a node can consider a neighboring node
reachable after receiving a reachability confirmation in millisecond.
To Next Page
Loading...
