D-Link xStack DGS-3620 Series - Page 639

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
634
DGS-3620-28PC:admin#config ipv6 neighbor_cache force_aging_addr add System
3FFC::1
Command: config ipv6 neighbor_cache force_aging_addr add System 3FFC::1
Success.
DGS-3620-28PC:admin#
52-5 show ipv6 neighbor_cache force_aging_addr
Description
This command is used to display the IPv6 force aging address in the neighbor cache.
Format
show ipv6 neighbor_cache force_aging_addr
Parameters
None.
Restrictions
None.
Example
This example shows how to display all the neighbor cache entries for the IP interface “System”.
DGS-3620-28PC:admin# show ipv6 neighbor_cache force_aging_addr
Command: show ipv6 neighbor_cache force_aging_addr
IPv6 Neighbor Cache Force Aging Address:
10::1 State: No Cache
MAC Address : NA Port : NA
Interface : System VID : 1
10::3 State: No Cache
MAC Address : NA Port : NA
Interface : System VID : 1
Total Entries: 2
DGS-3620-28PC:admin#
52-6 config ipv6 nd ns ipif
Description
This command is used to configure the NS retransmit time of a specified interface.