D-Link xStack DGS-3620 Series - Page 663

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
658
Parameters
ports - Specifies the list of ports used for this configuration.
<portlist> - Enter the list of ports used for this configuration here.
all - Specifies that all the ports will be usd for this configuration.
max_entry - Specifies the maximum number of entries.
<value 1-50> - Enter the maximum number of entries used here. This value must be between
1 and 50.
no_limit - Specifies that the maximum number of learned entries is unlimited.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To specify that a maximum of 10 entries can be learned by ND snooping on ports 1–3:
DGS-3620-28PC:admin# config address_binding nd_snoop ports 1-3 max_entry 10
Command: config address_binding nd_snoop ports 1-3 max_entry 10
Success.
DGS-3620-28PC:admin#
53-24 show address_binding nd_snoop
Description
This command is used to display the status of ND snooping on the Switch.
Format
show address_binding nd_snoop {ports <portlist>}
Parameters
ports – (Optional) Specifies the list of ports used for this display.
<portlist> - Enter the list of ports used for this display here.
Restrictions
None.
Example
To show the ND snooping state:
DGS-3620-28PC:admin# show address_binding nd_snoop
Command: show address_binding nd_snoop
ND Snoop : Enabled
DGS-3620-28PC:admin#