D-Link xStack DGS-3620 Series - Page 670

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
665
drop - Drop all the above rate limit DHCP packets when the port enters the under
attack state.
shutdown - Shut down the port when the port enters the under attack state.
no_limit – Disable DHCP snooping rate limiting. This is the default.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure limit 10pps DHCP packet on port 1:
DGS-3620-28PC:admin# config address_binding dhcp snooping ports 1:1 limit rate
10 mode drop
Command: config address_binding dhcp snooping ports 1:1 limit rate 10 mode drop
Success.
DGS-3620-28PC:admin#
53-34 config address_binding dhcp snooping recovery_timer
Description
This command is used to configure the auto recovery timer value.
Format
config address_binding dhcp snooping recovery_timer [<sec 60-1000000> | infinite]
Parameters
<sec 60-1000000> - Enter a value between 60 and 1000000 for the time interval used by the
auto-recovery mechanism.
infinite - Specifies that the port cannot be auto-recovered.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the auto-recovery time as 1000 seconds:
DGS-3620-28PC:admin# config address_binding dhcp snooping recovery_timer 1000
Command: config address_binding dhcp snooping recovery_timer 1000
Success.
DGS-3620-28PC:admin#