D-Link xStack DGS-3620 Series - Page 692

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
687
Format
show jwac ports {<portlist>}
Parameters
<portlist> - (Optional) Specifies a port range to show the configuration of JWAC.
Restrictions
None.
Example
To display JWAC ports 1 to 4:
DGS-3620-28PC:admin#show jwac ports 1-4
Command: show jwac ports 1-4
Port State Aging Time Idle Time Block Time Max
(min) (min) (sec) Hosts
----- -------- ---------- --------- ---------- -----
1 Disabled 1440 Infinite 60 100
2 Disabled 1440 Infinite 60 100
3 Disabled 1440 Infinite 60 100
4 Disabled 1440 Infinite 60 100
DGS-3620-28PC:admin#
54-27 clear jwac auth_state
Description
This command is used to clear authentication entries.
Format
clear jwac auth_state [ports [all | <portlist>] {authenticated | authenticating | blocked} |
mac_addr <macaddr>]
Parameters
ports - Specifies the port range to delete hosts on.
all - Specifies to delete all ports.
<portlist> - Enter range of ports to delete.
authenticated - (Optional) Specifies the state of host to delete.
authenticating - (Optional) Specifies the state of host to delete.
blocked - (Optional) Specifies the state of host to delete.
mac_addr - Delete a specified host with this MAC address.
<macaddr> - Enter the MAC address here.