D-Link xStack DGS-3620 Series - Page 754

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
749
Success.
DGS-3620-28PC:admin#
62-1 config loopdetect vlan
Description
This command is used to setup the loop-back detection function for the VLANs on VLAN-based
mode.
Format
config loopdetect vlan [<vid_list> | all] state [enable | disable]
Parameters
vlan - Specifies the VLAN(s).
<vid_list> - Enter the VLAN list.
all - Specifies that all VLANs will be used for this configuration.
state - Specifies whether the LBD function should be enabled or disabled on the VLANs
specified.
enable - Specifies that the LBD function will be enabled.
disable - Specifies that the LBD function will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the LBD function on VLANs 2 to 5:
DGS-3620-28PC:admin#config loopdetect vlan 2-5 state enable
Command: config loopdetect vlan 2-5 state enable
Success.
DGS-3620-28PC:admin#