D-Link xStack DGS-3620 Series - Page 841

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
836
74-7 show trusted_host
Description
This command is used to display the trusted hosts.
Format
show trusted_host
Parameters
None.
Restrictions
None.
Example
To display trusted hosts:
DGS-3620-28PC:admin#show trusted_host
Command: show trusted_host
Management Stations
IP Address Access Interface
----------------------------------------------------------------------------
10.48.93.100
10.51.17.1
10.50.95.90
Total Entries : 3
DGS-3620-28PC:admin#
74-8 config snmp system_name
Description
This command is used to configure the SNMP system name of the switch.
Format
config snmp system_name <sw_name>
Parameters
<sw_name> - Enter an SNMP system name for the switch. A maximum of 255 characters is
allowed.