D-Link xStack DGS-3620 Series - Page 842

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
837
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the switch SNMP name for “DGS-3620-28PC Gigabit Ethernet Switch”:
DGS-3620-28PC:admin# config snmp system_name DGS-3620-28PC Gigabit Ethernet
Switch
Command: config snmp system_name DGS-3620-28PC Gigabit Ethernet Switch
Success.
DGS-3620-28PC:admin#
74-9 config snmp system_location
Description
This command is used to enter a description of the SNMP system location of the switch. A
maximum of 255 characters can be used.
Format
config snmp system_location <sw_location>
Parameters
<sw_location> - Enter an SNMP system location for the switch. A maximum of 255 characters is
allowed.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the switch location for “HQ 5F”:
DGS-3620-28PC:admin#config snmp system_location HQ 5F
Command: config snmp system_location HQ 5F
Success.
DGS-3620-28PC:admin#