xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
850
Command: show packet groups 1
Group Number : 1
Frame Size/Type Frame Counts Frames/sec
--------------- ---------------------- -----------
64 22140 54
65-127 10459 13
128-255 3360 3
256-511 1506 0
512-1023 919 0
1024-1518 719 0
1519-1522 0 0
1519-2047 0 0
2048-4095 0 0
4096-9216 0 0
Unicast RX 2193 0
Multicast RX 14619 14
Broadcast RX 20791 56
RX Bytes 3972004 5221
RX Frames 37603 70
TX Bytes 1147852 0
TX Frames 1500 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
75-2 show error ports
Description
This command is used to display error statistics for a range of ports and a range of LAG groups..
Format
show error [ ports <portlist> | groups < grouplist >]
Parameters
ports - Specifies a range of ports to be configured. The start and end of the port list range are
separated by a dash.
<portlist> - Enter a port or range of ports to be displayed.
groups - Specifies a range of LAG groups to be displayed. The beginning and the end of the LAG
group list range are separated by a dash. eg: 3-4 specifies all of the LAG groups whose index
is between 3 and 4.
<grouplist> - Enter a number of a group to be displayed.
Restrictions
None.
Example
To display the errors of port 21:
To Next Page
Loading...
