D-Link xStack DGS-3620 Series - Page 870

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
865
Format
show syslog host {<index 1-4>}
Parameters
<index 1-4> - (Optional) Specifies the host index. If no parameter is specified, all hosts will be
displayed.
Restrictions
None.
Example
To display syslog host configurations:
DGS-3620-28PC:admin#show syslog host
Command: show syslog host
Syslog Global State: Disabled
Host 1
IP Address : 10.1.1.2
Severity : Warning
Facility : Local10
UDP port : 514
Status : Disabled
Host 2
IP Address : 3000:501:100:ffff:101:202:303:1
Severity : Emergency
Facility : Local10
UDP port : 514
Status : Disabled
Total Entries : 2
DGS-3620-28PC:admin#
75-20 config syslog source_ipif
Description
This command is used to force change the ipif information in syslogs. By default, syslogs will carry
the information of the ipif they belong to.
Format
config syslog source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]