D-Link xStack DGS-3620 Series - Page 871

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
866
Parameters
<ipif_name 12> - Enter the IP interface name. If only this parameter is specified, the IPv4
address and the smallest IPv6 address of ipif_name will be used as source IP addresses.
<ipaddr> - (Optional) Specifies the IP4 address.
<ipv6addr> - (Optional) Specifies the IPv6 global address.
none - Specifies to clear the configured source IP interface.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the syslog source IP interface:
DGS-3620-28PC:admin#config syslog source_ipif Sysetm
Command: config syslog source_ipif System
Success.
DGS-3620-28PC:admin#
To clear the configured source IP interface for syslog:
DGS-3620-28PC:admin#config syslog source_ipif none
Command: config syslog source_ipif none
Success.
DGS-3620-28PC:admin#
75-21 show syslog source_ipif
Description
This command is used to display the syslog source IP interface.
Format
show syslog source_ipif
Parameters
None.
Restrictions
None.
Example
To display the syslog source interface: