D-Link xStack DGS-3620 Series - Page 874

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
869
Parameters
l2 - (Optional) Specifies to display statistic counters of Layer 2 control packets.
l3 - (Optional) Specifies to display statistic counters of Layer 3 control packets.
unicast - Specifies to display statistic counters of Layer 3 unicast routing and Layer 3
application control packets.
multicast - Specifies to display statistic counters of Layer 3 multicast routing control packets.
type - (Optional) Specifies the type of packet that will be displayed. The protocol subtype will be
displayed.
lacp - Specifies to display packet type LACP.
stp - Specifies to display packet type STP.
gvrp - Specifies to display packet type GVRP.
erps - Specifies to display packet type ERPS.
cfm - Specifies to display packet type CFM.
802.1x - Specifies to display packet type 802.1X.
lldp - Specifies to display packet type LLDP.
oam - Specifies to display packet type OAM.
stacking - Specifies to display packet type Stacking.
ctp - Specifies to display packet type CTP.
ospfv2 - Specifies to display packet type OSPFv2.
ospfv3 - Specifies to display packet type OSPFv3. (EI Mode Only Parameter)
rip - Specifies to display packet type RIP.
ripng - Specifies to display packet type RIPng. (EI Mode Only Parameter)
bgp - Specifies to display packet type BGP. (EI Mode Only Parameter)
vrrp - Specifies to display packet type VRRP.
igmp - Specifies to display packet type IGMP.
mld - Specifies to display packet type MLD.
pim-ipv4 - Specifies to display packet type PIM-IPv4.
pim-ipv6 - Specifies to display packet type PIM-IPv6. (EI Mode Only Parameter)
dvmrp - Specifies to display packet type DVMRP. (EI Mode Only Parameter)
reserved_ipv4_ipmc - Specifies to display packet type reserved IPv4 IPMC.
reserved_ipv6_ipmc - Specifies to display packet type reserved IPv6 IPMC.
unknown_ipv4_ipmc - Specifies to display packet type unknown IPv4 IPMC.
unknown_ipv6_ipmc - Specifies to display packet type unknown IPv6 IPMC.
arp - Specifies to display packet type ARP.
icmp - Specifies to display packet type ICMP.
ndp - Specifies to display packet type NDP.
icmpv6 - Specifies to display packet type ICMPv6.
sntp - Specifies to display packet type SNTP.
dns - Specifies to display packet type DNS.
tftp - Specifies to display packet type TFTP.
rcp - Specifies to display packet type RCP.
telnet - Specifies to display packet type TELNET.
dhcp - Specifies to display packet type DHCP.
dhcpv6 - Specifies to display packet type DHCPv6.
udp-helper - Specifies to display packet type UDP-Helper.
Restrictions
None.
Example
To display statistics of all Layer 3 control packets:
DGS-3620-28PC:admin#show cpu port l3
Command: show cpu port l3
Type PPS Total Drop