D-Link xStack DGS-3620 Series - Page 879

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
874
Examples
To delete an NTP access group:
DGS-3620-28PC:admin# config ntp access_group delete 192.43.244.18
Command: config ntp access_group delete 192.43.244.18
Success.
DGS-3620-28PC:admin#
76-3 config ntp authentication state
Description
This command is used to enable or disable the NTP authentication.
Format
config ntp authentication state [enable | disable]
Parameters
enable - Specifies to enable the NTP authentication. This is the default value.
disable - Specifies to disable the NTP authentication.
Restriction
Only Administrators, Operators and Power Users can issue this command.
Examples
To enable NTP authentication:
DGS-3620-28PC:admin# config ntp authentication state enable
Command: config ntp authentication state enable
Success.
DGS-3620-28PC:admin#
76-4 config ntp authentication key add
Description
This command is used to add the authentication key for the NTP authentication.
Format
config ntp authentication key add <key_id> md5 <string 32>