D-Link xStack DGS-3620 Series - Page 911

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
906
DGS-3620-28PC:admin# show ospf host_route
Command: show ospf host_route
OSPF Host Route Settings
Host Address Metric Area ID
--------------- ------ ---------------
10.48.73.21 2 10.1.1.1
10.48.74.122 1 10.1.1.1
Total Entries : 2
DGS-3620-28PC:admin#
78-14 config ospf router_id
Description
The command is used to configure the router ID for the switch. Each switch that is configured to
run OSPF must have a unique router ID.
Format
config ospf router_id <ipaddr>
Parameters
<ipaddr> - Enter the router's IP address here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the router ID for the switch:
DGS-3620-28PC:admin# config ospf router_id 10.48.74.122
Command: config ospf router_id 10.48.74.122
Success.
DGS-3620-28PC:admin#
78-15 create ospf virtual_link
Description
This command is used to create an OSPF virtual link.