D-Link xStack DGS-3620 Series - Page 972

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
967
<value 0-128> - Enter the length of the mask value here. This value must be between 0 and
128. The default value is 126.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To configure the C-BSR on the interface “System”:
DGS-3620-28PC:admin# config pim6 cbsr ipif System state enable priority 64
hash_masklen 126
Command: config pim6 cbsr ipif System state enable priority 64 hash_masklen 126
Success.
DGS-3620-28PC:admin#
83-4 show pim6 cbsr
Description
This command is used to display the candidate bootstrap router information.
Format
show pim6 cbsr
Parameters
None.
Restrictions
None. (EI Mode Only Command)
Example
To show C-BSR settings on the switch:
DGS-3620-28PC:admin# show pim6 cbsr
Command: show pim6 cbsr
PIM6 Candidate-BSR Information
---------------------------------------------
C-BSR Interface Name : System
C-BSR Priority : 64
C-BSR Hash Mask Len : 126
DGS-3620-28PC:admin#