D-Link xStack DGS-3620 Series - Page 973

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
968
83-5 config pim6 crp
Description
This command is used to set the candidate rendezvous point (RP) related parameters.
Format
config pim6 crp [rp <ipif_name 12> | all] {priority <value 0-255> | interval <sec 1-16383>} (1)
Parameters
rp - Specifies the RP IP interface used.
<ipif_name 12> - Enter the RP IP interface name used here. This name can be up to 12
characters long.
all - Specifies that all the RP IP interfaces will be used.
priority - (Optional) Specifies the RP priority value that will be used in the election process. The
lower the value, the higher the priority.
<value 0-255> - Enter the RP priority value used here. This value must be between 0 and
255. The default value is 192.
interval - (Optional) Specifies the C-RP advertisement interval in seconds.
<sec 1-16383> - Enter the C-RP advertisement interval value here. This value must be
betwee 1 and 16383 seconds. The default value is 60 seconds.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To set the C-RP priority and the interval on the interface “System”:
DGS-3620-28PC:admin# config pim6 crp rp System priority 60 interval 60
Command: config pim6 crp rp System priority 60 interval 60
Success.
DGS-3620-28PC:admin#
83-6 create pim6 crp group
Description
This command is used to add a multicast group range into a C-RP serve list.
Format
create pim6 crp group <ipv6networkaddr> rp <ipif_name 12>
Parameters
group - Specifies the IPv6 group address range served by the RP.
<ipv6networkaddr> - Enter the IPv6 network address used here.