User's Manual
257
On the event configuration page, select Actions > Smart Tracking to enable the action.
8.4.1.12 Report Alarm
Click Actions and then select Report Alarm to enable this function. Where there is an alarm, the
system reports the alarm to alarm center.
Make sure that alarm center has been enabled. For details, see "8.3.2.8 Alarm Center".
8.4.1.13 Audio and Light Alarm
Set audio and light alarm for IVS detection. When there is an alarm, the system associates with the
remote device to perform audio and light actions.
Audio and light alarm is available when AI by camera is used for IVS detection and the camera
supports this function.
Step 1 Click Actions and select Camera Audio and Remote Warning Light.
Figure 8-47 Camera audio
Figure 8-48 Remote warning light
Step 2 Configure the parameters.
Table 8-18 Audio and light alarm parameters
Camera Audio
File Name
Select the audio file to be played when an alarm is
triggered.
Play Mode Set the play times of audio file.
Remote Warning
Light
Mode Select
or
.
Flicker Frequency
When
is selected as
, set the flicker
frequency.
Duration
Set how long the warning light flickers or keeps on
after an alarm is triggered.
To Next Page
Loading...
Need help?
General
