User's Manual
40
5 Initial Settings
When using the Device for the first time, initialize the device, and set basic information and functions
first.
5.1 Initializing the Device
If it is your first time to use the device after purchasing or after restoring factory defaults, set a login
password of admin (system default user). At the same time, you can set a proper password
protection method.
This section uses remote initialization on the web interface as an example.
Procedure
Step 1 Open the browser, enter IP address, and then press the Enter key.
The default IP addresses of network port 1 to network port 4 are 192.168.1.108 to
192.168.4.108. Enter the corresponding IP address of the actually connected network port.
Step 2 Set the language and region, select the video standard that is used in your region, and
then click
Device Initialization
.
●
PAL is mainly used in China, Middle East and Europe.
●
NTSC is mainly used in Japan, United States of America, Canada and Mexico.
Figure 5-1 Region
Step 3 Configure the time parameters, and then click
Next
.