102 | System Configuration Commands
www.dell.com | support.dell.com
Mode
Privileged Exec
Command
History
Example
Figure 6-34. Command Example: show port
Report Fields Intf—Valid unit, slot and port number separated by forward slashes. This field only displays for show
port all.
Type—If not blank, this field indicates that this port is a special type of port. The possible values are:
Mon—This port is a monitoring port. Look at the Port Monitoring screens to find out more
information.
Lag—This port is a member of a port-channel (LAG).
Probe—This port is a probe port.
Admin Mode—Selects the Port control administration state. The port must be enabled in order for it to
be allowed into the network—May be enabled or disabled. The factory default is enabled.
Physical Mode—Selects the desired port speed and duplex mode. If auto-negotiation support is
selected, then the duplex mode and speed will be set from the auto-negotiation process. Note that the
port's maximum capability (full duplex -100M) will be advertised. Otherwise, this object will determine
the port's duplex mode and transmission rate. The factory default is Auto.
Physical Status—Indicates the port speed and duplex mode.
Link Status—Indicates whether the Link is up or down.
Link Trap—This object determines whether or not to send a trap when link status changes. The factory
default is enabled.
LACP Mode—Displays whether LACP is enabled or disabled on this port.
Version 2.3 Modified: Revised to include VLAN interface IDs in the Interface column of the report.
(Force10_S50) #show port 1/0/1
Admin Physical Physical Link Link LACP
Intf Type Mode Mode Status Status Trap Mode
------ ------ ------- ---------- ---------- ------ ------- -------
1/0/1 Enable Auto 100 Full Up Enable Enable
(Force10_S50) #show port all
Admin Physical Physical Link Link LACP
Intf Type Mode Mode Status Status Trap Mode
------ ------ ------- ---------- ---------- ------ ------- -------
1/0/1 Enable Auto Down Enable Enable
1/0/2 Enable Auto 1000 Full Up Enable Enable
1/0/3 Disable Auto Down Enable Enable
1/0/4 Disable Auto Down Enable Enable
1/0/5 Disable Auto Down Enable Enable
1/0/6 Disable Auto Down Enable Enable
1/0/7 Disable Auto Down Enable Enable
1/0/8 Disable Auto Down Enable Enable
1/0/9 Disable Auto Down Enable Enable
1/0/10 Disable Auto Down Enable Enable
1/0/11 Disable Auto Down Enable Enable
1/0/12 Disable Auto Down Enable Enable
1/0/13 Disable Auto Down Enable Enable
1/0/14 Disable Auto Down Enable Enable
1/0/15 Disable Auto Down Enable Enable
1/0/16 Disable Auto Down Enable Enable
1/0/17 Disable Auto Down Enable Enable
1/0/18 Disable Auto Down Enable Enable
--More-- or (q)uit
(Force10_S50) #
To Next Page
Loading...
