420 | Routing Commands
www.dell.com | support.dell.com
show ip vrrp
This command displays whether VRRP functionality is enabled or disabled on the SFTOS switch. It
also displays some global parameters which are required for monitoring This command takes no
options.
Syntax
show ip vrrp
Mode
Privileged Exec and User Exec
Report Fields VRRP Admin Mode—Displays the administrative mode for VRRP functionality on the switch.
Router Checksum Errors—Represents the total number of VRRP packets received with an invalid
VRRP checksum value.
Router Version Errors—Represents the total number of VRRP packets received with Unknown or
unsupported version number.
Router VRID Errors—Represents the total number of VRRP packets received with invalid VRID for this
virtual router.
show ip vrrp interface
This command displays all configuration information and VRRP router statistics of a virtual router
configured on a specific interface.
Syntax
show ip vrrp interface unit/slot/port vrID
Mode
Privileged Exec and User Exec
Report Fields IP Address—This field represents the configured IP Address for the Virtual router.
VMAC address—Represents the VMAC address of the specified router.
Authentication type—Represents the authentication type for the specific virtual router.
Priority—Represents the priority value for the specific virtual router.
Advertisement interval—Represents the advertisement interval for the specific virtual router.
Pre-Empt Mode—Is the preemption mode configured on the specified virtual router.
Administrative Mode—Represents the status (Enable or Disable) of the specific router.
State—Represents the state (Master/backup) of the specific virtual
show ip vrrp interface brief
This command displays information about each virtual router configured on the SFTOS switch. This
command takes no options. It displays information about each virtual router.
Syntax
show ip vrrp interface brief
To Next Page
Loading...
Need help?
General
