Dell Force10 S2410-01-10GE-24P Command Reference

302 | LAG/Port Channel Commands
www.dell.com | support.dell.com
protocol static
This command converts the selected LAG (port channel) from LACP mode to static.
Syntax
protocol static
Default
disabled
Mode
Interface Port Channel Config
Usage
LAGs are in LACP mode by default. After you use this command to convert a LAG to static, if you
want to revert the LAG to LACP mode, you would use the protocol lacp command.
Command
History
rate-interval
This command is available in the Interface Port Channel Config mode.
See rate-interval on page 98 in the System Configuration chapter.
service-policy
This command is available in the Interface Port Channel Config mode.
See service-policy on page 357 in the System Configuration chapter.
set garp timer join
This command is available in the Interface Port Channel Config mode.
See set garp timer join on page 251 in the GARP Commands chapter.
set garp timer leave
This command is available in the Interface Port Channel Config mode.
See set garp timer leaveall on page 253 in the GARP Commands chapter.
interface range Defines an interface range and accesses the Interface Range mode
protocol static Convert the LAG to static mode.
Version 2.5.1 Introduced, in the new Interface Port Channel Config mode, to replace
port-channel staticcapability.
Related
Commands
interface port-channel Accesses the Interface Port Channel Config mode for the selected port
channel.
interface range Defines an interface range and accesses the Interface Range mode
protocol lacp Revert the LAG to LACP mode.

Dell Force10 S2410-01-10GE-24P Specifications

General

Manageable	Yes
Jumbo Frame Support	Yes
Product Type	Switch
Uplink Ports	4 x 10 Gigabit SFP+
MAC Address Table Size	32K entries
Operating Temperature	0 °C to 40 °C
Storage Temperature	-40 °C to 70 °C
Power Supply	Internal