DHCP Server Commands | 237
ip dhcp pool
This command configures a DHCP address pool name on a DHCP server and enters DHCP Pool
Config mode.
Syntax
ip dhcp pool name
The no version of this command removes the DHCP address pool. The name should be a previously
configured pool name.
Default
none
Mode
Global Config Mode
lease
This command configures the duration of the lease for an IP address that is assigned from a DHCP
server to a DHCP client.
The no version of this command restores the default value of the lease time for DHCP Server.
Syntax
lease {[days [hours] [minutes]] | [infinite]}
The overall lease time should be between 1-86400 minutes. If infinite is specified, lease is set for 60
days. Days is an integer from 0 to 59. Hours is an integer from 0 to 1439. Minutes is an integer from 0
to 86399.
Default
1 (day)
Mode
DHCP Pool Config
network
This command is used to configure the subnet number and mask for a DHCP address pool on the
server. Network-number is a valid IP address, made up of four decimal bytes ranging from 0 to 255. IP
address 0.0.0.0 is invalid. Mask is the IP subnet mask for the specified address pool. The prefix-length
is an integer from 0 to 32.
The no version of this command removes the subnet number and mask.
Syntax
network networknumber [mask | prefixlength]
no network
Default
none
Mode
DHCP Pool Config
To Next Page
Loading...
