Dell Force10 S2410-01-10GE-24P - Set Igmp Mcrtexpiretime (Interface); Set Igmp Mcrtexpiretime All

282 | IGMP Snooping Commands
www.dell.com | support.dell.com
no set igmp mcrtrexpiretime
Default
0
Mode
Global Config
Related
Commands
set igmp mcrtexpiretime (interface)
Command
History
Related
Commands
set igmp mcrtexpiretime all
This command sets the Multicast Router Present Expiration time on the system for all the interfaces.
This is the amount of time in seconds that a switch will wait for a query to be received on an interface
before the interface is removed from the list of interfaces with multicast routers attached. The range is
0 to 3600 seconds. A value of 0 indicates an infinite timeout, i.e. no expiration.
The no version of this command sets the Multicast Router Present Expiration time on all interfaces to
0. A value of 0 indicates an infinite timeout, i.e. no expiration.
Syntax
set igmp mcrtexpiretime all 0-3600
no set igmp mcrtexpiretime all
Default
0
Mode
Global Config
Related
Commands
igmp enable (interface) Enables IGMP Snooping on a selected interface.
set igmp mcrtrexpiretime
(global)
Sets the Multicast Router Present Expiration time on the system for all the
interfaces.
show igmpsnooping Displays IGMP Snooping status information.
Version 2.3
Revised to
igmp mcrtexpiretime.
igmp enable
(interface)
Enables IGMP Snooping on a selected interface.
show igmpsnooping Displays IGMP Snooping status information.
igmp enable
(interface)
Enables IGMP Snooping on a selected interface.
show igmpsnooping Displays IGMP Snooping status information.