Dell Force10 S2410-01-10GE-24P - Bootpdhcprelay Maxhopcount; Bootpdhcprelay Minwaittime; Bootpdhcprelay Serverip

408 | Routing Commands
www.dell.com | support.dell.com
bootpdhcprelay maxhopcount
This command configures the maximum allowable relay agent hops. The parameter has a range of 1 to
16.
The no version of this command sets the maximum allowable hops to the default.
Syntax
bootpdhcprelay maxhopcount 1-16
no bootpdhcprelay maxhopcount
Default
4
Mode
Global Config
bootpdhcprelay minwaittime
This command configures the minimum wait time in seconds for BootP/DHCP Relay on the system.
When the BOOTP relay agent receives a BOOTREQUEST message, it MAY use the
seconds-since-client-began-booting field of the request as a factor in deciding whether to relay the
request or not. The parameter has a range of 0 to 100 seconds.
The no version of this command configures the default minimum wait time in seconds for BootP/
DHCP Relay on the system.
Syntax
bootpdhcprelay minwaittime 0-100
no bootpdhcprelay minwaittime
Default
0
Mode
Global Config
bootpdhcprelay serverip
This command configures the server IP address of the DHCP server. The ipaddr parameter is an IP
address in a 4-digit dotted decimal format.
The no version of this command configures the default server IP Address for BootP/DHCP Relay on
the system.
Syntax
bootpdhcprelay serverip ipaddr
no bootpdhcprelay serverip
Default
0.0.0.0
Mode
Global Config