Dell Force10 S2410-01-10GE-24P - Match Cos; Match Dstip; Match Destination-Address Mac

Quality of Service (QoS) Commands | 341
The total number of class rules formed by the complete reference class chain (includes both
predecessor and successor classes) must not exceed a platform-specific maximum.
In some cases, each removal of a refclass rule reduces the maximum number of available rules in the
class definition by one.
match cos
This command adds to the specified class definition a match condition for the Class of Service value
(the only tag in a single tagged packet or the first or outer 802.1Q tag of a double VLAN tagged
packet). The value may be from 0 to 7.
Syntax
match cos 0-7
Default
none
Mode
Class Map (The prompt is “(Config-classmap)#”.)
match destination-address mac
This command adds to the specified class definition a match condition based on the destination MAC
address of a packet.
Syntax
match destination-address mac macaddr macmask
The macaddr parameter is any Layer 2 MAC address formatted as six, two-digit hexadecimal numbers
separated by colons (e.g., 00:11:22:dd:ee:ff). The macmask parameter is a Layer 2 MAC address bit
mask, which need not be contiguous, and is formatted as six, two-digit hexadecimal numbers separated
by colons (e.g., ff:07:23:ff:fe:dc).
Default
none
Mode
Class Map (The prompt is “(Config-classmap)#”.)
match dstip
This command adds to the specified class definition a match condition based on the destination IP
address of a packet.
Syntax
match dstip ipaddr ipmask
The ipaddr parameter specifies an IP address. The ipmask parameter specifies an IP address bit mask;
note that although similar to a standard subnet mask, this bit mask need not be contiguous.
Default
none
Mode
Class Map (The prompt is “(Config-classmap)#”.)