Dell Force10 S2410-01-10GE-24P - Arp Resptime; Arp Retries; Arp Timeout

Routing Commands | 393
arp resptime
This command configures the ARP request response timeout.
The value for seconds is a valid positive integer, which represents the IP ARP entry response timeout
time in seconds. The range for seconds is between 1-10 seconds.
The no version of this command configures the default ARP request response timeout.
Syntax
arp resptime 1-10
no arp resptime
Default
l
Mode
Global Config
arp retries
This command configures the ARP count of maximum request for retries.
The value for retries is an integer, which represents the maximum number of request for retries. The
range for retries is an integer between 0-10 retries.
The no version of this command configures the default ARP count of maximum request for retries.
Syntax
arp retries 0-10
no arp retries
Default
4
Mode
Global Config
arp timeout
This command configures the ARP entry ageout time.
The value for seconds is a valid positive integer, which represents the IP ARP entry ageout time in
seconds. The range for seconds is between 15-21600 seconds.
The no version of this command configures the default ARP entry ageout time.
Syntax
arp timeout 15-21600
Default
1200
Mode
Global Config