Dell Force10 S2410-01-10GE-24P - Network Protocol

System Management Commands | 41
Related
Commands
network mac-address
This command is replaced by the mac-address command in Version 2.3.
Mode
Privileged Exec
Command
History
network mac-type
This command is replaced by the mac-type command in Version 2.3.
Mode
Privileged Exec
Command
History
network parms
Command
History
network protocol
Command
History
protocol
This command specifies the network configuration protocol to be used for the management VLAN.
Syntax
protocol {bootp | dhcp | none}
interface managementethernet Invokes the (Config-if-ma)# prompt, where you can set up a
management IP interface (the ip address command; see next).
ip address (management) Configures the IP address of the management interface.
show interface Displays a summary of statistics for a specific port, including the
management port, or a count of all CPU traffic based upon the
argument.
Version 2.3
Introduced. Replaced by the mac-address
command.
Version 2.3
Introduced. Replaced by the mac-type
command.
Version 2.3
Deprecated: Replaced, in part, by
management route default for the gateway part of the
management address. Replaced, in part, by interface managementethernet and ip address
(management).
Version 2.3
Replaced by the
protocol command.