Dell Force10 S2410-01-10GE-24P Command Reference

240 | DHCP Server Commands
www.dell.com | support.dell.com
Lease expiration—The lease expiration time of the IP Address assigned to the client.
Type—The manner in which IP Address was assigned to the client.
show ip dhcp global configuration
This command displays address bindings for the specific IP address on the DHCP server. If no IP
address is specified, the bindings corresponding to all the addresses are displayed.
Syntax
show ip dhcp global configuration
Mode
Privileged Exec and User Exec
Service DHCP—The field to display the status of dhcp protocol.
Number of Ping Packets—The maximum number of Ping Packets that will be sent to verify that an ip
address id not already assigned.
Excluded Address—The ranges of IP addresses that a DHCP server should not assign to DHCP clients.
show ip dhcp pool configuration
This command displays pool configuration. If all is specified, configuration for all the pools is
displayed.
Syntax
show ip dhcp pool configuration {name | all}
Mode
Privileged Exec and User Exec
Pool Name—The name of the configured pool.
Pool Type—The pool type.
Lease Time—The lease expiration time of the IP Address assigned to the client.
DNS Servers—The list of DNS servers available to the DHCP client
Default Routers—The list of the default routers available to the DHCP client
The following additional field is displayed for Dynamic pool type:
Network—The network number and the mask for the DHCP address pool.
The following additional fields are displayed for Manual pool type:
Client Name—The name of a DHCP client.
Client Identifier—The unique identifier of a DHCP client.
Hardware Address—The hardware address of a DHCP client.

Dell Force10 S2410-01-10GE-24P Specifications

General

Manageable	Yes
Jumbo Frame Support	Yes
Product Type	Switch
Uplink Ports	4 x 10 Gigabit SFP+
MAC Address Table Size	32K entries
Operating Temperature	0 °C to 40 °C
Storage Temperature	-40 °C to 70 °C
Power Supply	Internal