Dell Force10 S2410-01-10GE-24P - Remotecon Timeout

74 | System Management Commands
www.dell.com | support.dell.com
The oe version of this command sets the maximum number of remote connection sessions that can be
established to the default value.
Default
5
Syntax
remotecon maxsessions 0-5
no remotecon maxsessions
Mode
Privileged EXEC
remotecon timeout
This command sets the remote connection session timeout value, in minutes. A session is active as long
as the session has been idle for the value set. A value of 0 indicates that a session remains active
indefinitely. The time is a decimal value from 0 to 160.
The no version of this command sets the remote connection session timeout value, in minutes, to the
default.
Default
5
Syntax
remotecon timeout 0-160
no remotecon timeout
Mode
Privileged EXEC
Note: Changing the timeout value for active sessions does not become effective until the
session is reaccessed. Any keystroke will also activate the new timeout duration.